Tag: installation

Installing a terminal server on Microsoft Windows Server

The below blog post will show you how to install make a Microsoft Windows Server a Terminal Server. This was done on a Microsoft Windows Server 2019 Datacenter.

A Terminal Server makes it possible for multiple users to access a Windows Server through Remote Desktop (also called RDP). A normal Windows Server installation is limited to two (2) multiple users.

First off you need to get Terminal Services installed on the Windows Server if this is not already installed.

1.
To do this you need to start Windows PowerShell as an administrator and execute the command below.

Command: Install-WindowsFeature RDS-RD-Server -IncludeManagementTools

2.
Then you need to set the license server under in the Local Group Policy Editor. This is done from the Edit Group Policy located in the Control Panel.

Go to Computer Configuration\Administrative Templates\Windows Components\Remote Desktop Services\Remote Desktop Session Host\Licensing

And choose Use the specified Remote Desktop license servers to set the server.

Here you need to insert the license server provided.

3.
Then you need to set the license mode under in the Local Group Policy Editor. This is done from the Edit Group Policy located in the Control Panel.

Go to Computer Configuration\Administrative Templates\Windows Components\Remote Desktop Services\Remote Desktop Session Host\Licensing

And choose Set the Remote Desktop licensing mode

Here you most likely want to choose Per User

Getting information about your SAS-installation

Below is a couple of commands that can be used to get information about your SAS-installation.

proc setinit;
run;

The Setinit-command will give you information about the SAS-products that your SAS-installation is licensed for.

proc product_status;
run;

The Product_status-command will give you information about the SAS-products installed on your system.
Keep in mind that there could be a difference between what’s licensed on your system and what’s actually installed.
The commands above will only give you information about the products installed for base-SAS. If you want information about what other SAS-products is installed on you system, then you can get this SAS-program from SAS and run it on your system.